ATE-DMG 1000 Watt Programmable Linear DC Power Supplies
Kepco’s 1000 watt instrument-grade digital power supplies, Series ATE-DMG, are programmable linear low-noise power supplies designed to respond very quickly and precisely to voltage and current setting instructions delivered interactively by the GPIB (IEEE 488.2) or from a front panel keypad.
Series ATE-DMG are derived from Kepco’s Series ATE precision analog power supplies. A 24-key keypad augments the rotary voltage and current controls and a 2-line 16-character LCD display replaces the meters. The GPIB interface is built-in offering full talk-listen functionality on the bus. The display shows both the settings and the actual voltage and current readings which also can be read back on the bus, upon command.
Key Features
-
1000 Watt Linear DC Power Supplies
-
8 models 6, 15, 25, 36, 55, 75, 100 and 150 Volt
-
Linear control for low noise: 100 micro-volts typical in voltage mode
-
high precision: 0.0005% source effect {regulation} in voltage mode.
-
high speed mode allows fast-recovery current-controlled stabilization into a varying load.
-
Over voltage and over current settings individually programmed by the front panel keypad or remotely by the bus with a programmable delay to allow for reactive-load transients.
-
Over voltage crowbar to protect sensitive loads.
-
Non-volatile storage of programmed sequences or active settings.
-
Full talk-listen control from a GPIB (IEEE 488-2) using SCPI language.
-
Master-slave series and parallel operation to provide increased capability.
-
Local control: Front panel keypad entries are used for setting and adjusting the output.
-
5 Year Warranty
More Information
Please use the form below to request more information.